Lanbon L8 Smart Switch Panel

Board or product name and model

Lanbon L8 Smart Switch Panel Processor: ESP32-WROVER-B

Link to the product listing or datasheet

devices.esphome.iohttps://devices.esphome.io/devices/lanbon_l8/

Display controller and resolution, if known

Display: ST7789 (using ili9xxxx plaform)

Touch controller, if known

Touchscreen: 6336

Do you own this board and can test it?

Yes, I have it and can test

Anything else

esp32: variant: esp32 framework: type: esp-idf

psram: speed: 80MHz

output:

• platform: ledc pin: GPIO5 id: backlight_pwm
• platform: ledc pin: GPIO26 id: moodRed
• platform: ledc pin: GPIO32 id: moodGreen
• platform: ledc pin: GPIO33 id: moodBlue
• platform: gpio pin: GPIO12 id: relay_1
• platform: gpio pin: GPIO14 id: relay_2
• platform: gpio pin: GPIO27 id: relay_3

light:

• platform: monochromatic name: "Backlight" id: backlight output: backlight_pwm restore_mode: ALWAYS_ON

Older devices use 3-channel RGB moodlight

• platform: rgb name: "Mood Light" red: moodRed green: moodGreen blue: moodBlue

Newer devices use a WS2811 controller

Make sure to disable the output on GPIO26

#- platform: esp32_rmt_led_strip

rgb_order: RGB

pin: GPIO26

num_leds: 8

chipset: ws2811

name: "Mood Light"

spi: clk_pin: GPIO19 mosi_pin: GPIO23 miso_pin: GPIO25

i2c: sda: GPIO4 scl: GPIO0

display:

• platform: mipi_spi model: LANBON-L8

touchscreen: platform: ft63x6 calibration: x_min: 0 y_min: 0 x_max: 230 y_max: 312 on_release: - if: condition: lvgl.is_paused then: - lvgl.resume: - lvgl.widget.redraw: - light.turn_on: backlight

lvgl: on_idle: timeout: !lambda "return 10000;" then: - light.turn_off: backlight - lvgl.pause: pages: ...