thank you for this wonderful project.
I'm exploring all the features. And asking myself, is it possible to use a connected speaker with an Guition ESP32-S3 ? For announce or sound confirmation.
if you look on the back of the guition 4 inch at the print.
I've there are resistors at R25,R26 and R27 the 3 relais are working (black square on my picture)
I've there are resistors at R21,R22 and R23 the mediaplayer is working. (red squere)
They have the same printing path
If youβre good at SMD soldering, you can remove the old 0-ohm resistors and connect the other pads
Discussion 2
Add a commentI too would very much like to understand if this was a possibilty please?
Β· Edited
if you look on the back of the guition 4 inch at the print. I've there are resistors at R25,R26 and R27 the 3 relais are working (black square on my picture) I've there are resistors at R21,R22 and R23 the mediaplayer is working. (red squere) They have the same printing path
If youβre good at SMD soldering, you can remove the old 0-ohm resistors and connect the other pads